Bonding in a Clima Control System

This lasered product is very complex. The liner of the front and the back side  is cutted during the process without turning it. This enables a compliance of minimum tolerances (± 0,15 mm). Also the production of tight bars and extreme small contours is unproblematic. Furthermore the liner functions as finger lift as well as positioning and spacer aid. It is produced a little bit smaller than the opening so that the adhesive is not touched in the positioning process.  

You have a similar project and are wondering if we can support you?

Simply write us a short mail or call us directly. We are at your disposal for all your questions. | Phone +49 5181-80687-0